Mechanical Engineering Interview Questions



·         What is water hammering?
·         What are the available tests to check pH?
·         What is turbidity and what is the cause for it?
·         Differences between COD and BOD?
·         Differences between reactive silica and colloidal silica and their effects?
·         What happens to the turbine blades when silica is present in the dm water?
·         What is the limit for storing inergen cylinders inside the plant without any PESO approval?
·         What are the limits to consider a pipe line or a tube to be IBR?
·         What is the difference between a tube and pipe?
·         What are the advantages of using Natural Gas over HSD or LSHS?
·         What are the different valves that you encountered till now?
·         During HCl filling in the tank, HCl fumes will generate, what are the means to absorb these fumes?
·         Why PVC balls are used in DM water tank?
·         Which has a higher COP, Vapor compression or vapour absorption?
·         What is flocculation?
·         What are the effects if minerals are present in DM water?
·         What is the function of anthracite in a water treatment plant?
·         What is the effect of free chlorine on resins?
·         What are the different losses in a cooling tower and what is their percentage
·         What is the difference between Furnace oil and LSHS?
·         What is the function of Tatory stripper in Process Plant?
·         What are the checks to be performed before starting a motor?
·         What is the maximum NOx level permitted?
·         What are the factors that affect corrosion?
·         What are the factors that influence scaling?
·         What are the factors that influence fouling?
·         What are the various types of cooling water corrosion?
·         What are the ways and means to control corrosion?
·         Why clearance between impeller and back plate needs to be maintained, what happens if it increases or decreases and how is it measured?
·         What all are the types of level transmitters available?
·         What all are the types of flow transmitters available?
·         Bicarbonates of Ca & Mg are responsible for  _____________ and chlorides, sulphates & Nitrates of Ca & Mg are responsible for  ________________
·         What are the steps to be followed in gun cleaning activity?
·         What are the methods of Boiler preservation and when are they preferred?
·         What is the material used for cold insulation?
·         What are the steps followed in Laser alignment?
·         What is the equation for temperature and pressure compensation for flow calculation?
·         What is the low level alarm set point for Deaerator?
·         What is fuel gas minimum pressure control loop in boiler?
·         What is the minimum capacity of a hydrocarbon tank required for PESO approval?

No comments: